%{tishi_zhanwei}%

J52-12 Chlorinated Rubber High Build Surface Paint

J52-12 Chlorinated Rubber High Build Surface Paint

Intended Uses Paint film is tough, with good mechanical strength, good weather resistance, sealing, moisture and waterproof, its one-time filming is thick. It is applicable to anti-corrosion of ship, container, outdoor steel structure and concrete facility.
Product Description  It is prepared by chlorinated rubber paint, synthetic, polymer resin, pigments and fillers, thixotropic agent, plasticizer, additive and solvent. (Various colors)
Product Information Volume Solids 35%
Dry Film Thickness 50 microns
Theoretical Coverage 180~220g/m2 5.68m2 /L(calculated by 50μm dry film)
Practical Coverage Allow appropriate loss
Application Details Method of Application
Airless Spray Recommended-Tip range: 17-21mm; Total fluid pressure: 15-20 Mpa
Brush or Roller Recommended, only for small area.
Conventional Spray Adoptable but thin to 5-10%, Tip range:2-2.5mm
Thinner X-14
Cleaner X-14
Storage Life One year
Drying
Time
Substrate
Temperature
Touch
Dry
(h)
Hard
Dry
(h)
Overcoating Interval
Minimum Maximum
25℃ 2 8 8 hours No limit
Painting number Suggest two coats of painting, dry film reaches 50~100μm
Storage and Handing Storage Store in cool and dry conditions
Pack Size 20kg
Flash Point 38℃
Specific Gravity Approx 1.10-1.20kg/L
Specification and Surface Preparation   If preceding paint has been polluted, appropriate methods shall be used to remove grease and dust and this lacquer diliuent can be used to clean.
Preceding Paint   Chlorinated rubber aluminum powder high-build anti-rust paint, chlorinated rubber high build underitint anti-rust paint, chlorinated rubber iron oxide red high build anti-rust paint and epoxy micaceous iron oxide anti-rust paint, etc.
Limitations Substrate temperature must be 3℃ higher than dew point above, and relative humidity must be less than 85%.
Safety Precautions This product should be used in painting area by professional operations. When painting, please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.
This product is a kind of solvent-based paint. In order to avoid danger or accident, minimal safety precautions, as follow, should be done;
The paint contains volatile solvent and is flammable. So must keep away form sparks and open flames. No smoking at application site. Effective precautions (such as using explosion-proof electrical equipments, no static electricity accumulation or metal collision etc) also should be done so as to avoid producing sparks. Flash point of paint, mentioned above o Product Data Sheet, is the lowest temperature at which mixture of the volatile materials of paint can ignite or explode with air.
Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general. Therefore, 200m3 of ventilation quantity per 1kg solvent (according to the solvent) is necessary.
Protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eye protection, face masks, barries creams and so on). If paint gets in touch with skin, wash fully with a large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately.
Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation. Handle empty containers with care and do not bring about environmental contamination.
NOTICE: If consumers have not taken effective safety precautions (Refer to the specifications), out company will NOT be responsiblefor any accident.