C04-9 Alkyd Micaceous Iron Oxide Anti-corrosive Paint/Finish, Grey

Intended Uses	Used for ferrous mental surface as intermediate coat and finish, grey. Suited for painting the railway, brideg or other various steel structures in atmosphere environment.
Product Description	It forms a coat with good adhesion and resistance to moisture, weathering, good compatibility with primer of finish, in accordance with the demands of finish standard for railway and bridge.
Product Information	Volume Solids		40%
	Dry Film Thickness		50 microns equivalent to 125 microns of wet film.
	Theoretical Coverage		161g/m²
	Pratical Coverage		Allow appropriate loss
Application Details	Mix Ratio		One package
	Method of Application
	Airless Spray		Recommended-Tip range 15-18 inch thou, Total output fluid pressure: 17.6MPa
	Brush or Roller		Recommended
	Thinner		X-6
	Cleaner		X-6
	Pot Life		No limit
	Storage Life		One year
	Drying Time	Substrate Temperature	Touch Dry （h）	Hard Dry （h）	Overcoating Interval
					Minimum	Maximum
		5℃ 23℃ 35℃	6 4 2	24 18 12	24 hours 16 hours 10 hours	No limit
Storage and Handing	Storage		Store in cool and dry conditions
	Pack Size		20kg in 20 liter container
	Flash Point		35℃
	Specific Gravity		1.36kg/L
Specification and Surface Preparation	New steel: The surface must be rust-removed to Swedish St3 or Sa2.5. Other conditions, please refer to related section of alkyd primer.
Limitations	Recommend coat: Paint 2 coats with airless spray in order to reach 60 microns of dry film thickness, other conditions are the same as alkyd red lead anti-corrosive paint.
Safety Precautions	This product should be used in painting area by professional operations. When painting, please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product. This product is a kind of solvent-based paint. In order to avoid danger or accident, minimal safety precautions, as follow, should be done; The paint contains volatile solvent and is flammable. So must keep away form sparks and open flames. No smoking at application site. Effective precautions (such as using explosion-proof electrical equipments, no static electricity accumulation or metal collision etc) also should be done so as to avoid producing sparks. Flash point of paint, mentioned above o Product Data Sheet, is the lowest temperature at which mixture of the volatile materials of paint can ignite or explode with air. Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general. Therefore, 200m3 of ventilation quantity per 1kg solvent (according to the solvent) is necessary. Protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eye protection, face masks, barries creams and so on). If paint gets in touch with skin, wash fully with a large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation. Handle empty containers with care and do not bring about environmental contamination. NOTICE: If consumers have not taken effective safety precautions (Refer to the specifications), out company will NOT be responsiblefor any accident.