%{tishi_zhanwei}%

J53-11 Chlorinated Rubber Aluminum Powder High-build Anti-rust Paint

J53-11 Chlorinated Rubber Aluminum Powder High-build Anti-rust Paint

Intended Uses It is appliable to low temperature construction, with strong adhesive force, rapid dry, good waterproof, anti-corrosion and altrenate drying-wetting performances. It is applied to anti-rust of ship bottom and anti-corroison of ship waterline, steel structure under water, underground pipeline and steel structure.
Product Description It is prepared chlorinated rubber resin and aluminum powder, plasticzer, auxiliary and slovent. (Silver and light aluminum red)
Product Information Volume Solids 35%
Dry Film Thickness 70 microns
Theoretical Coverage 260g/m2,5.08m2/L(calculated by 70μm dry film)
Pratical Coverage Allow appropriate loss
Application Details Mix Ratio It is all right by stirring evenly
Method of Application
Brush or Roller Recommended, only for small area.
Conventional Spray Adoptable but thin to 5-10%, Tip range:2-2.5mm
Thinner X-14
Cleaner X-14
Pot Life No limit
Storage Life One year
Drying
Time
Substrate
Temperature
Touch
Dry
(h)
Hard
Dry
(h)
Overcoating Interval
Minimum Maximum
25℃ 2 8

8 hours

No limit
Storage and Handing Storage Store in cool and dry conditions
Pack Size 20kg
Flash Point 38℃
Specific Gravity Approx 1.32kg/L
Specification and Surface Preparation If directly coat on steel, the steel requires shot-blasting or sand-blasting to Swedish Derusting Standard Sa2.5 and ont the surface with ship primer shall need secondary derusting to Swedish Derusting Standard to St3.
Preceding Paint Epoxy zinc rich shop primer, epoxy iron oxide red shop primer and inorganic zinc silicat primer, etc. (it can be directly painted on steel surface in accordance with anti-rust quality requirements).
Subsequent Paint Chloirnated rubber surface paint and various high chlorinated polyethylene surface paints and acrylic surface paints.
Limitations Substrate temperature must be 3℃ higher than dew point above, and relative humidity must be less than 85%
Safety Precautions This product should be used in painting area by professional operations. When painting, please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.
This product is a kind of solvent-based paint. In order to avoid danger or accident, minimal safety precautions, as follow, should be done;
The paint contains volatile solvent and is flammable. So must keep away form sparks and open flames. No smoking at application site. Effective precautions (such as using explosion-proof electrical equipments, no static electricity accumulation or metal collision etc) also should be done so as to avoid producing sparks. Flash point of paint, mentioned above o Product Data Sheet, is the lowest temperature at which mixture of the volatile materials of paint can ignite or explode with air.
Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general. Therefore, 200m3 of ventilation quantity per 1kg solvent (according to the solvent) is necessary.
Protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eye protection, face masks, barries creams and so on). If paint gets in touch with skin, wash fully with a large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately.
Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation.
Handle empty containers with care and do not bring about environmental contamination.
NOTICE: If consumers have not taken effective safety precautions (Refer to the specifications), out company will NOT be responsiblefor any accident.