C53-34 Alkyd Micaceous Iron Oxide Anti-rust Paint

Intended Uses	It has good adhesive force, good moisture resistance performance, atmospheric corrosion resistance and strong bonding with bottom surface. For ferrous metal, it can be used as intermediate paint and anti-rust paint.
Product Description	It is prepared by long oil pentaerythritol alkyd resin, micaceous iron oxide, aluminum paste, drier and solvent, etc. (reddish-brown and grayish brown)
Product Information	Volume Solids		67%
	Dry Film Thickness		40 microns
	Theoretical Coverage		80g/m²，16.25m²/L(calculated by 40μm dry film)
	Practical Coverage		Allow appropriate loss
Application Details	Method of Application
	Airless Spray		Recommended-Tip range: 17-21mm; Total fluid pressure: 15-20 Mpa
	Brush or Roller		Recommended, only for small area.
	Conventional Spray		Adoptable but thin to 5-10%, Tip range:2-2.5mm
	Thinner		X-6
	Cleaner		X-6
	Pot Life		No limit
	Storage Life		One year
	Drying Time	Substrate Temperature	Touch Dry （h）	Hard Dry （h）	Full Solidification （d）	Overcoating Interval
						Minimum	Maximum
		25℃	2	24	7	24 hours	No limit
Storage and Handing	Storage		Store in cool and dry conditions
	Pack Size		25kg
	Flash Point		35℃
	Specific Gravity		Approx 1.35kg/L
Specification and Surface Preparation	Steel surface requires sand blasting or shot blasting to Swedish Derusting Standard Sa2.5, or grinded to St3 by electric tools.
Preceding Paint	Epoxy zinc rich, inorganic zinc rich paint, Red lead phenolic antirust paintand alkyd iron oxide red anti-rust paint.
Subsequent Paint	Alcohol acid surface paint.
Limitations	Substrate temperature must be 3℃ higher than dew point above, and relative humidity must be less than 85%.
Safety Precautions	This product should be used in painting area by professional operations. When painting, please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product. This product is a kind of solvent-based paint. In order to avoid danger or accident, minimal safety precautions, as follow, should be done; The paint contains volatile solvent and is flammable. So must keep away form sparks and open flames. No smoking at application site. Effective precautions (such as using explosion-proof electrical equipments, no static electricity accumulation or metal collision etc) also should be done so as to avoid producing sparks. Flash point of paint, mentioned above o Product Data Sheet, is the lowest temperature at which mixture of the volatile materials of paint can ignite or explode with air. Enough ventilation is necessary at application site. In order to remove any danger of explosion, must keep the ratio of gas to air is less than 10%, the minimum explosive limit in general. Therefore, 200m3 of ventilation quantity per 1kg solvent (according to the solvent) is necessary. Protect skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eye protection, face masks, barries creams and so on). If paint gets in touch with skin, wash fully with a large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation. Handle empty containers with care and do not bring about environmental contamination. NOTICE: If consumers have not taken effective safety precautions (Refer to the specifications), out company will NOT be responsiblefor any accident.